Information

Lamé candle holders

Lamé candle holders

Equipment

Scissors 1 scouring sponge in fine metal mesh 1 straight water glass (top: 6.5 cm; bottom: 5 cm, maximum height: 11 cm) 1 fondue candle

Production

1 '- Preparation of the sponge

Cut the two ends (crosswise) of the metal sponge with scissors, 1 cm from the edge. Remove the foam plate inside. S1608396W300 Cut the two ends of the sponge

3 '- Assembly of the different elements

At one end, bend a hem of about 1.5 cm towards the inside of the tube, without fixing it. Thread the glass through the side of the tube that has a hem. S1608412W300 Bend a hem towards the inside of the tube.



1 '- Finishing

Place water inside the glass and float a fondue candle.

Advice

The metallic mesh of the sponge does not offer the same effect inside and out, so you can vary the pleasures ... by using each of them. 20 Metal and wire objects © éditions Flammarion, 2004